Front Panel (N-70Ae) - Pioneer N-50AE Bedienungsanleitung

> Before Start > Part Names
Front Panel
(N-70AE)
Part Names

1. Í/I STANDBY/ON button/indicator: Switch the main power of the unit on and off. While
the unit is starting up, the indicator in the center of the button slowly flashes blue, then
lights blue when it has started.
2. STANDBY indicator: Lights red when the unit is in standby mode.
3. DIRECT indicator: Lights when the DIRECT mode is on. (
4. Hi-Bit32 indicator: Lights when the Hi-Bit32 feature is on. (
5. Up Sampling indicator: Lights when the Up Sampling feature is on. (
6. Display ( P8)
7. SOURCE button: Switches the input to be played.
8. Play buttons:
: This button stops playback.
∫
/; : This button pauses the playback.
1
: Move to the track before the one being played.
:6
: Move to the next track.
59
0 Depending on the input, these buttons may be disabled.
9. Remote control sensor
10.USB port: Connect a USB storage device or HDD (hard disk drive) to play music files. You
> Install
   
 
P24)
P24)
P24)
> Initial Setup > Playback

can also supply power (maximum 5 V/0.5 A) to USB devices with a USB cable.
0 When connecting a HDD that requires more than 5 V/0.5 A, connect to the USB port
(maximum 5 V/1 A) on the rear of the unit.
11. PHONES jack: Connect headphones with a standard plug (‰6.3 mm diameter).
12.PHONES LEVEL dial: Adjust the volume of the headphones.
Supplementary information | Advanced Setup | Others
 
 
E
N
3