Important Instructions; Faulty Electrical Connection Cable - Parkside 273460 Originalbetriebsanleitung

G B I E
reduction in the performance of the
machine, as well as a reduction in the
cutting accuracy.
• Avoid switching the machine on by
accident: when inserting the plug into
the socket, the power button must not
be pressed.
• Use the tool which is recommended
in this manual. This will ensure the
optimal performance of your saw.
• Keep your hands away from the
working area when the machine is in
operation.
• Before you carry out any adjustments
or servicing work, turn the device off
and remove the mains plug.
5. Electrical Connection
The installed electric motor is
connected ready for operation.
The connection complies with the
relevant VDE and DIN regulations.
The customer's network connection
and any extension cable used must
comply with these regulations.
• The product meets the requirements
of EN 61000-3-11 and is subject to
special connection conditions. This
means that its use at freely selectable
connection points is not permitted.
• If the network conditions are unfa-
vourable, the device may result in
temporary voltage fluctuations.
• The maximum permitted mains
impedance at the electrical connec-
tion point of 0.107 ohm must not be
exceeded.
• As the user, you must ensure – in
consultation with your electricity sup-
ply company if necessary – that the
continuous current carrying capacity
1 6
of the network at the connection point
to the public mains is sufficient for the
connection of the product.

Important Instructions

If the motor is overloaded, it switches
itself off automatically. After cooling down
(times vary), the motor can be switched on
again.
Faulty Electrical
Connection Cable
Insulation damage often occurs to electrical
connection cables.
The causes of this may be as follows:
• Pressure points if connection cables
are routed through windows or door
gaps.
• Kinks caused by improper attachment
or routing of the connection cable.
• Cut surfaces caused by vehicles dri-
ving over the connection cable.
• Insulation damage caused by tearing
out of the wall socket.
• Cracks resulting from the insulation
becoming old.
Such faulty electrical connections must not
be used and may endanger life due to the
damage to the insulation.
Electrical connection cables should be
checked regularly for damage. Ensure that
during such checks, the connection cable is
not connected to the mains.
Electrical connection cables must comply
with the relevant VDE and DIN regulati-
ons. Only use connection cables with the
marking H05VV-F.
It is stipulated by law that the type of con-
nection cable must be printed on it.