Led Indicators And Control Panel; Thermostat Setting Button - Beko BU 1200 HCA Bedienungsanleitung

1
LED indicators and control
panel
LED indicators in the front section of
your refrigerator are intended to help
you in monitoring the operation of your
appliance.
Keep your food in the refrigerator in a
safe manner by monitoring and using
these LEDs and controls as explained
below:
Fast Freeze Button (1): Used to
freeze the food fastly. Compressor may
not operate immediately but after some
time when the button is pressed and
this is quite normal.

Thermostat Setting Button (2):

Used to set your refrigerator between
minimum and maximum values.
The appliance may go to OFF position
when the knob is adjusted below MIN.
When the green indicator light is OFF,
the appliance is turned OFF also.
Once it is turned OFF (even for
defrosting), please adjust the knob
somewhere above MIN to be sure
that it is turned ON again. When the
appliance is turned ON, the green
indicator will light up.
2 5
Orange LED (3): Lights up when the
fast freeze button on the LED panel is
pressed. In this case, your refrigerator
operates continuously.
Press the button again when the food
you would like to fast freeze comes to
the desired temperature and the orange
LED will turn off.
Green LED (4): Lights up continuously
after plugging in your refrigerator.
Red LED (5): It warns you by lighting
up continuously when your refrigerators
start to operates, if not enough cooling
effect is obtained, when the door
remains open for a long time and when
excessive food is loaded.
If the red LED lights up continuously
when the conditions stated in the
adjacent column do not exist, then call
our Authorized Service.
15
EN
4 3