Final Assembly; Start-Up; Maintenance; Cleaning - Maico AKE 100 Betriebsanleitung

UK │ 8. Mounting ̶ Electrical connection

8.5 Final assembly

Before fitting the electronics cover,
check the location of the external
climate sensor's connection cable to
make sure that the mounting of the
internal climate sensor is not
blocked.
Danger of short-circuits and
NOTICE
damage to the unit. Humidity
will penetrate if electronics
cover is not fitted correctly.
Press electronics cover firmly
onto housing such that it is
sealed and flush all the way
around. When doing so, do not
press setting buttons [15] and
[16].
1. Insert electronics cover [6] into housing
recesses I, II and III, until the 3 locking
tabs snap into place. Press the electronics
cover firmly on to the housing at the points
indicated by the arrows.
2. Insert the supplied internal climate sensor
[5] correctly ( arrow X) in the connector
sockets.
3. Fit cover [4].
20

8.6 Start-up

1. Switch the mains fuse on.
2. Run function test.
3. Save reference humidity by pushing button
1 [15].
4. Fit designer cover [3].
Saving of the reference values is
shown by LED 1 blinking.

9. Maintenance

The unit is maintenance-free.

10. Cleaning

Danger to life from electric
shock.
DANGER
Switch the mains fuse off.
Risk of damage to unit if
NOTICE
incorrect cleaning agent is
used.
Only use water to clean cover [4]
and designer cover [3]. Do not
use aggressive cleaning agents.
1. Only use a dry cloth to clean the internal
parts of the fan.
2. If the designer cover [3] is very dirty,
remove it carefully from the fan and clean
with water.
3. Fit designer cover [3].