Britton 4Way Bedienungsanleitung Seite 9

not too hot before placing the child in the child car seat.
• Security is only guaranteed if the child car seat is fitted in accordance with these instructions.
EN
• Failure to comply with the above instructions will automatically void the warranty and exempt
Britton from any liability.
• Store this car seat in a safe place when it is not being in used. Avoid placing heavy objects on
top of it. Do not allow your child car seat to contact with corrosive substances e.g. battery acid.
NOTICE:
1. This is a "Universal" child restraint .It is approved to ECE Regulation No.44.04 series of
amendments, for general use in vehicles and it will fit most, but not all, car seats.
2. A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the
vehicle is capable of accepting a "Universal" child restraint for this age group.
3. This child restraint has been classified as "Universal" under more stringent conditions as
those which applied to earlier designs which do not carry this notice.
4. lf in doubt, consult either the child restraint manufacturer or retailer.
This child restraint is only suitable if the vehicle is fitted with a type approved 3 point with re-
tractor safety belt, in compliance with standard UN / ECE Regulation No.16 or other equivalent
standards.
1. LIST OF PARTS (Fig. 1)
A - Adjusting ring of the headrest
B - Backrest
C - Headrest
D - Shoulder pads
E - Harness buckle
F - Backrest belt hook
G - Headrest belt guide
H - Shoulder straps
I - Crotch pad
J - Shoulder strap adjusting button
K - Harness adjust strap
L - Turning knob for adjusting backrest angle
M - Shoulder strap height adjust board
N - Shoulder pads fastener belt
O - Metal anchor
P - Shaft nut
Q - Seat base
R - Diagonal belt guide
2. HARNESS ADJUSTMENT
2.1 Releasing the harness system
Press the shoulder strap adjusting button (J) with one hand and pull the shoulder straps to
release it (Fig. 2).
Important! For group 2 and 3, without harness system, go directly to 2.2.
2.2 Adjusting harness system and headrest
Adjust the headrest by pulling the adjusting ring of the headrest (A). Harness system is adjust-
ed simultaneously (Fig. 3).
Warning! Make sure the harness is on the same height as your child's shoulders. Otherwise
adjust the harness on the suitable height (Fig. 4).