Commisioning; Safety Instructions; Maintenance And Troubleshooting - bürkert 8071 Bedienungsanleitung

8.

commisioninG

8.1.

safety instructions

Warning
risk of injury due to nonconforming commissioning.
Non conforming commissioning may lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of the manual.
• In particular, observe the safety recommendations and intended
use.
• The device / the installation must only be commissioned by
suitably trained staff.
Protect this device against electromagnetic interference,
ultraviolet rays and, when installed outdoors, the effects of
the climatic conditions.
The pipe must be full of liquid whitout air bubbles.
→
Drain air from the pipe by gradually filling the pipe with fluid.
→
Make sure the installation is tight.
16
English
Type 8071
Commisioning
9. mAinTenAnce AnD
TroubleshooTinG
9.1. safety instructions
danger
risk of injury due to high pressure in the installation.
• Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to electrical voltage.
• Shut down and isolate the electrical power source before
carrying out work on the system.
• Observe all applicable accident protection and safety regula-
tions for electrical equipment.
risk of injury due to the nature of the fluid.
• Respect the prevailing regulations on accident prevention and
safety relating to the use of aggressive fluids.
risk of injury due to high fluid temperatures.
• Use safety gloves to handle the device.
• Stop the circulation of fluid and drain the pipe before loosening
the process connections.
• Keep all easily flammable material and fluid away from the
device.