Cleaning Methods; Cleaning Tips - Kärcher Puzzi 100 Handbuch

For considerate treatment of the environ-
ment use detergent economically.
 Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
see Figure 4
 Insert dirt water reservoir into the appli-
ance and attach lid.
 Plug in the main plug.
 Press the suction switch to turn on the
suction turbine.
Press the spray switch to turn on the de-
tergent pump.
see Figure 5
Warning
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
 Use the lever on the bender to spray on
detergent solution.
Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
see Figure 6
 In case of work interruptions, the floor
nozzle can be stored in the handle.
see Figure 12
Empty the dirt water reservoir.
 If the dirt water reservoir is full, switch
off the suction and spray switches.
 Remove the lid.
 Remove the dirt water reservoir from
the appliance and empty it.
see figures 7 and 8

Cleaning methods

Normal soiling
 Spray and suction off detergent solution
in one work cycle.
Note
A repeated suctioning without spraying will
shorten the drying time.
Strong soiling or stains
 Apply detergent solution with suction
turbine turned off and soak for 10 to 15
minutes.
 Clean the surface just like with normal
soiling.
 In order to further improve the cleaning
result, the surface can be recleaned us-
ing clear, warm water.
Highly soiled spots should be pre-
–
soaked and the detergent solution
should soak 5 to 10 minutes.
Always work from the light to the shade
–
(from the window to the door).
Always work from the cleaned to the un-
–
cleaned surface.
The more sensitive the surface (oriental
–
rugs, berbers, upholstery material) the
lower the cleaning solution concentra-
tion should be.
Rugs with jute backing can shrink if too
–
much water is used and can bleed col-
ours.
Brush high-fiber rugs in the direction of
–
the weave after cleaning (using a fiber
brush or a scrubber).
Water-proofing the fabric using Care
–
Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face.
Do not step on cleaned surfaces until
–
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
– 3
EN

Cleaning tips

11