W Arning - Batteries; Operation; Bluetooth ® Pairing - Hama KEY4ALL X2100 Bedienungsanleitung

5. Getting Started
arning – Batteries
W
• Immediately remove dead batteries from the
product and dispose of them.
• Only use batteries (or rechargeable batteries) that
match the specified type.
• Do not mix old and new batteries or batteries of a
different type or make.
• When inserting the batteries, make sure that the
polarity is correct ('+' and '-' markings). Failure
to do so could result in the batteries leaking or
exploding.
• Do not charge non-rechargeable batteries.
• Keep batteries out of the reach of children.
• Do not short circuit batteries/rechargeable
batteries and keep them away from uncoated
metal objects.
• Open the battery compartment. Remove the contact
breaker. Replace the battery compartment cover.
Battery switch
• Open the battery compartment, remove and properly
dispose of the dead batteries and insert 2x new AAA
batteries with the correct polarity. Close the battery
compartment.
• If the battery charge is low, the Caps Lock / Power LED
(6) begins to flash red during operation. Replace the
batteries immediately as described above.
Stand function
• Fold out the feet from beneath the keyboard (7) and
release the retaining flaps from the feet (8).
• With the retaining flaps folded out, position your tablet
between the keyboard and the retaining flaps.
• To close the stand, proceed in the reverse order.

6. Operation

Note
• The functions described in this section are only
available for Bluetooth
• Note that the maximum range for Bluetooth
is 10 metres without obstacles such as walls,
people, etc.
6.1 Bluetooth pairing
®
Note – Pairing
• Make sure that your Bluetooth
device is on and Bluetooth
• Make sure that your Bluetooth
device is visible for other Bluetooth
• For more information, please refer to the operating
instructions of your terminal device.
• Slide the [OFF/ON] switch (2) to the ON position to
switch on the Bluetooth
Power LED (6) emits a green light for ten seconds.
• First select one of the three Bluetooth
the following shortcut keys:
- fn + Q for the 1st Bluetooth
- fn + W for the 2nd Bluetooth
- fn + E for the 3rd Bluetooth
• The channel is selected as soon as the corresponding
Bluetooth status LED ((3), (4) or (5), depending on
®
selected channel) briefly lights up in blue.
• Press and hold the [fn + letter of the selected channel]
keys for five seconds to start the pairing process.
• When you release the shortcut key, the Bluetooth
status LED flashes blue.
• The keyboard is searching for a Bluetooth
• Open the Bluetooth
®
KEY4ALL X2100 appears in the list of Bluetooth
devices found.
• Select Hama KEY4ALL X2100, follow any instructions
on your terminal device, and wait until the keyboard is
shown as connected in the Bluetooth
terminal device. The Bluetooth
(5), depending on selected channel) goes out.
• You can now use the Bluetooth
-capable terminal devices.
®
-capable terminal
®
is activated.
®
-capable terminal
®
devices.
®
keyboard. The Caps Lock /
®
channels using
®
channel
®
channel
®
channel
®
connection.
®
settings and wait until Hama
settings on your
®
status LED ((3), (4) or
®
keyboard.
®
®
®
®
3