Upgrade Firmware - VOLTCRAFT DL-200T Bedienungsanleitung

16. UPGRADE FIRMWARE

• Download the latest data logger firmware from the product page on
www.conrad.com.
•
Press the button DOWN (6) several times until the 4 digit logger
identifier and "ID" are shown on the display.
Press and hold the button ENTER (8) until the 4 digit logger ID is
replaced by "
• Connect the data logger to your computer.
• Drag and drop the firmware to the data logger drive on your computer.
• Data logger starts upgrading. During this period the data logger shown
as a mass storage device disappears for a short while from your
computer. Do not disconnect data logger from your computer!
• Once the data logger appears as a mass storage device again, the
upgrade is finished. Green LED control light flashes twice.
• Disconnect from your computer.
The firmware version of the data logger can be checked in the left
bottom corner of the PDF report.
long
press
ENTER
".
91