TFA 98.1009 Bedienungsanleitung Seite 38

Press th AL/HR (hour) button to set the hours and press the MODE/MIN (minutes) button
1.
to set the minutes.
2. Press the SNOOZE button to confirm the setting and exit automatically to Calender
setting.
3.
Note: The Projection clock will still try and receive the signal despite the time being manually set. When it
receives the signal, then the DCF tower icon will stay fixed on the LCD. If reception has been
unsuccessful, then the DCF tower icon will disappear but reception will still be attempted the
following hour.
CALENDAR SETTING
The date default of the Projection Alarm clock is SA 1.1. in the year 2005. Once the radio-controlled time
signals are received, the date is automatically updated. However, if the signals are not received, you can
adjust the date manually. To do this:
1. The year digits start flashing. Use the MODE/MIN button to set the year (the range runs from 2005 to
2049).
2. Press the SNOOZE button again to enter the month and date setting (flashing).
3. Use the AL/HR button to set the day and the MODE/MIN button to set the month
4. Press the SNOOZE button again to enter the weekday setting (flashing).
5. Use the MODE/MIN button to set the weekday.
6.
Press the SNOOZE button to confirm all settings and to exit or do not touch any buttons fpr about 10
seconds. The mode will return to normal.
38