Placing The Unit; Ac Power (220V / 110V); Connections (Noise Issues); Trademarks - XTZ EDGE A2-300 Bedienungsanleitung

Placing the unit

Allow adequate ventilation. Do not place the unit on a soft surface like a carpet. Do not place it in an enclosed
position such a bookcase or cabinet that may impede the air-flow through the ventilation slots.
AC Power
To power the unit, connect the supplied power cord to the unit and a standard AC power outlet. The unit itself
recognizes the prevailing voltage so you don't need to adjust it to your local voltage level. In standby mode
(220V / 110V)
the EDGE A2-300 consumes less than 0,3W.
Connections
To ensure a safe management of the amplifier and speakers, always only connect and disconnect
signal cables and speaker cables when the amplifier is shut off with the main switch on the back side.
(Noise issues)
Always use signal and speaker cables as short as possible and of good quality. Long
signal cables of poor quality works as antennas, and might in some cases create noise.
Always connect using the correct phase, from the plus (+) pole on the amplifier to the plus (+) pole on the
loudspeaker and respectively for the minus (-) pole.
Earth ground is often used to reduce noise from electrical interference from outside the casing, however in
some cases several electrical devices which are connected to the same grounding grid can create loops that
pick up interference i.e. ground loops. There are a couple of ways to fix this problem:
•
•

Trademarks

ICEpower is a registered trademark of ICEpower a/s
XTZ is a trademark of XTZ Group AB
Cleaning the
Switch off all components of your system when cleaning any of the components. Clean surfaces with a soft
dry cloth only.
product
Use the same power strip / power outlet for the interfering equipment.
Use short as possible signal cables of high quality to minimize resistance and impedance.
5