Installing The Main And Additional Intercom Panels - Philips WelcomeEye Connect Anleitung

4. Installing the main and additional intercom panels

Warning:
The product should not be connected to the power supply before the wiring is
completed.
1
4
DES 9900 VDP
5 3 1 0 0 6
1 2
1 2
1 2 3 4 5 6 7 8
1 2
DES 9900 VDP
CFI Extel
5 3 1 0 0 6
ZI de Fétan, 01600 Trévoux
FRANCE
20V 110mA
RFID 125kHz
IP44
7
1 - Remove the anti-theft screw from the intercom panel.
2 - Tip the intercom panel cover forward.
3 - The panel's lens should be positioned at a height of around 1.60 m from the ground.
4 - Locate where to drill the holes.
5 - Drill.
6 - Use the plugs adapted to the support (the screws provided are suitable for solid walls).
7 - Connect the two wires coming from the monitor, and if necessary, connect the electric
strike plate and the gate (see section 1). Wiring). Configure the switches at the back of
the intercom panel (see section 2. Setting up the intercom).
8 - Insert the screws and refit the two caps concealing the retaining screws.
9 - Replace the front panel of the intercom and tighten the anti-theft screw.
10 - Connect the 230V AC power supply to the modular adaptor (for installation in
2
5
2 1
2
8
WelcomeEye Connect / Touch / 08/17
3
6
1
9
1m60
GB8