Setting / Adjustment; Assembly; Mains Connection - Mafell S 35 M Originalbetriebsanleitung

Absauggerät

Vorschau ausblenden

100

101

102

Inhaltsverzeichnis

Verfügbare Sprachen

- Particular care should be exercised when

vacuuming stairs. Pay attention to safe footing.

- The socket outlet on the device may only be used

for the purposes defined in the operating

instructions.

- Never work without the protection devices

prescribed for the respective operating sequence

and do not make any changes to the device that

could impair safety.

- When operating the device outdoors, the use of an

earth-leakage circuit-breaker is recommended.

- Damaged cables or plugs must be immediately

replaced.

- Children and adolescents may not operate this

device. This rule does not apply to young persons

receiving training and being supervised by an

expert.

- Switch off the device before carrying out

maintenance and after every use and unplug the

power plug.

- Always check before starting any work whether the

suction hoses are safely attached and undamaged.

- Do not pull the plug by its cable out of the socket

outlet.

- Pull out the power plug prior to cleaning or

emptying and prior to eliminating any malfunctions.

- Pay attention that the cable is protected against oil

and heat and cannot be damaged by being driven

over, crushed or pulled.

- Consider environmental influences. Do not expose

the device to rain and avoid working near

combustible liquids or gases.

- Store the device in a dry, locked place outside the

reach of children.

- Regular cleaning of the device is an important

safety factor. Pull the plug before starting this

work.

- The device must be set up on level ground such

that it can neither tilt over nor roll away (lock

steering rollers).

- The cleaned air may only be recirculated to those

workspaces from where it was extracted; i.e. the

electronic tool and the dust extractor may only be

operated in the same workspace.

- In case of leaking foam or water, immediately

switch off the device. Empty container and where

necessary folded filter.

- Acid, acetone and solvents may corrode device

components.

- Do not leave the device unattended. Pull the power

plug in case of longer work interruptions.

- If the device's connecting cable is damaged, it

must be replaced by a special connecting cable

that is available from the manufacturer or his after-

sales service.

- Have repairs only carried out by skilled workers,

e.g. by the after-sales service. If not professionally

repaired, devices will constitute a danger for the

user.

- Only

use

original

accessories or special accessories. Otherwise, the

manufacturer will not accept any warranty claims

and cannot be held liable.