IPC Gansow 1010 E Bedienungsanleitung Seite 25

Before carrying out any work on the
machine,make sure that it is off and that all
its functions are disabled. This is done by
turning the key switch 3, fig.3 OFF.
7.10 - REPLACING AND REGULATING
THE CENTRE BRUSH LIFTING CABLE
To replace the centre brush lifting cable:
-Turn the handle 2 to OFF.
-Lift the top bonnet.
-Loosen the screws fastening the top and bottom side casings.
-Remove the top and bottom side casings.
-Remove the bolt fastening the handle to the handle support.
-Loosen the screws 41.
-Open up the handle 2.
-Remove the sheath and wire.
-Unscrew and remove the clamp.
-Remove the clip 9.
-Remove the fork from the rocker.
-Remove the cable 6 from the sheath 5.
Reassembling:
-Turn the handle 2 to ON.
-Slot the cable 6 into the sheath 5.
-Hook the fork to the rocker and lock it in place with the clip 9.
-Fit the clamp to the cable and fix it so that when the handle 2 is in
ON position the striker cap touches the reference stop.
-Fit the clamp into the handle and tighten the screws 41.
-Secure the handle 2 to its fastening element 3.
-Reassemble the machine's casings.
ENGLISH (Translation of original instructions)
7.11 REMOVING THE REAR WHEEL GEAR
MOTOR GROUP
1 Remove the rear bin, the batteries, the top right side casing and the
two bottom casings.
2 By means of a shim A set under the machine, lift the machine up from
the ground in a way that the back wheels are not touching the floor.It
is raccommanded to position the side flaps in a way they aren't
damaged during the operation.
3 Remove the upper cover.
4 Loosen the 2 fixing screws that keep the cover of the electrical box
shut and take the cover away.
5 Disconnect the power supply cables of the gear motor from the
control card.
6 After cutting the plastic cable binds, remove the sheath containing
the gear motor power supply cables from the right side of the machine.
7 Loosen the 6 screws that fix the gear motor group to the chassis.
Now you can take the group out of the machine.It is recommended to
carry out this operation with the help of another person. There is a layer
of silicone between the gear motor group and machine and the former
may be slightly difficult to detach without help.
A
Fig. 9
Pag. 10