Ready To Start; Controlling The Model; Tips And Tricks - Carson Speed Shark Nano Betriebsanleitung

READY TO START

1. Switch on RC unit (red status LED flashes)
Important: The boat is not yet ready for use !!
2. Place the boat in the water (red status LED goes out)
The model boat is nopw ready to go (safety circuit !!! - both
contacts must be in the water).

CONTROLLING THE MODEL

Caution
To avoid losing control: ALWAYS move the control lever S-L-O-W-L-Y!
• Actuate function buttons (control commands) to select the desired direction of travel.
• the selected commands are indicated by the red status LED.$
Operation indicator
Forward
Forward
Backward
Power switch
DIRECTIONAL GUIDE
Straight ahead travel and the speed of the boat can be changed
by means of the mechanical setting of the rudder.
Directional guide
OFF
ON
Charging indicator
Backward
Right turn
Left turn

TIPS AND TRICKS

If, as the result of an unforeseeable manoeuvre, water should
enter the hull of the boat, this can be very simply removed. To do
this, the screws on the underside of the boat must be undone (the
number can differ from model to model).. Remove the water and
dry the electronics with a hair dryer.
11 // GB