Installation; Inserting/Replacing The Battery; Mounting; Operation Via Power Unit - EuroLite FL-100 Bedienungsanleitung

Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

INSTALLATION

Inserting/Replacing the battery

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.

Mounting

When standing the device on a plane surface, please extract the 3 legs.
If the device is used as torch, please extract the 3 legs and insert them in the fixation holes of the shaft.
Hanging installation:
The installation of the device has to be built and constructed in a way that it can hold 5 times the weight for 1
hour without any harming deformation.
Before rigging make sure that the installation area can hold a minimum point load of 5 times the device's
weight.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.

Operation via power unit

Caution: Before connecting the power unit, the batteries must be removed.
Connect the connection cable of the power-unit (6 V DC, 700 mA) with the DC IN-socket. Plug the power unit
into your outlet.
10/19 51114550_V_2_0.DOC