Setting The Address Of Several "Es-1 - VOLTCRAFT ES-1 Bedienungsanleitung

7. Setting the address of several "ES-1"

The address code of the "ES-1" is set ex works to the address "5". If more
than one "ES-1" should be used, then the pre-set address must be modified.
To this effect, the addresses "5" to "8" are available.
• Press the "ES-1" button for approximately 5 seconds until the indicator
lamp lights up at the "ES-1".
• Release the button.
• Now the indicator lamp flashes according to the set address, i.e. it
flashes five times with address "5".
• If you wish to set another address, briefly press the button once in order
to switch to the following higher address.
The new address is acknowledged via the corresponding flashing of the
indicator.
• Press the button once more for approximately 5 seconds until the display
indicator goes out.
• Now register the "ES-1" again as described in chapter "6 Putting into
operation".
• In this way, a total of up to four "ES-1" can be registered at the main
device "Energy Control 3000 USB" on the addresses 5 to 8.
21