Tool Specifications; Machine Elements; Intended Use - Bosch GDS 30 PROFESSIONAL Bedienungsanleitung

3 609 929 345 - Buch Seite 1 Freitag, 5. Dezember 2003 12:16 12

Tool Specifications

Impact Wrench
Order number
Rated input power*
Output power
No-load speed
max. torque for hard/soft screwdriving
application according to ISO 5393
Right/Left rotation
Screw diameter, max.
Tool holder
Weight without cable, approx.
Protection class
Please observe the order number of your machine. The trade names of the individual machines may vary.
* The values given are valid for nominal voltages [U] of 230/240 V. For lower voltages and models for specific countries,
these values can vary.

Machine Elements

The numbering of the machine elements refers to
the representation of the machine on the graph-
ics page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Suspension eyelet
2 Auxiliary handle
3 Thread for auxiliary handle
4 On/Off switch
5 Rotational direction switch
6 Tool holder
Not all of the accessories illustrated or described are
included as standard delivery.

Intended Use

The machine is intended to screw-in and loosen
bolts, as well as to tighten and loosen nuts within
the respective range of dimension.
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed.
11 • 3 609 929 345 • 03.12
GDS 24
PROFESSIONAL
0 601 434 1..
[W] 800
[W] 400
[rpm] 1 260
[Nm] 600/300
M 24
3/4"
[kg] 5.7
/ II
Wear protective glasses and hearing protec-
tion.
Wear sturdy shoes.
If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Do not op-
erate the machine in rain or moisture.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always direct the cable to the rear away from
the machine.
Always switch the machine off and wait until it
has come to a standstill before placing it down.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
English - 1
GDS 30
PROFESSIONAL
0 601 435 1..
920
500
1 260
1 000/500
M 30
1"
7.3
/ II