Completing Installation - Dometic FlyTec FT200 Montage- Und Bedienungsanleitung

Installing the flyscreen
5.5

Completing installation

Riveting the cassette profile with the cover profile for the C pillar
(fig. 8, page 6)
➤ Put all the blind rivets (4 x 8 mm with stainless steel mandrel) through the
drill holes and rivet the components using a hand riveter.
Tensioning the guide cables
➤ Tension the guide cables on the deflection screws on the skirting board
and the top guide rail (fig. 9, page 6).
The tension of the cables affects the guidance and smooth running of the
handle strip. By changing the tension of the upper and lower cable, you can
adjust the parallel orientation of the handle strip to the right door edge.
➤ Secure the safety clips onto the deflection screws each with a screw
(M2.5 x 6 mm) (fig. 9 1 and 2, page 6).
14
Dometic FlyTec FT200
EN