JVC TK-C9510E Bedienungsanleitung Seite 19

Connection Settings
Control Signal Cable Connection on Camera (Rear)
+ +
- -
TX TX RX RX
A B C D
CAMERA
Rear Switch Settings (A page 26)
Set the [RX TERM OFFlON] switch.
Set only the camera connected by the control signal line to "ON". Set to
"OFF" for all other cameras.
Menu Screen Settings (A page 34)
① Select the [MAINTENANCE] item on the [MENU] screen, and
press the [SET] button.
The [MAINTENANCE] screen appears.
② Move the cross key up/down to select the [COMMUNICATION]
item, move the cross key to the left/right to set to "JCCP",
followed by pressing the [SET] button.
The [COMMUNICATION (JCCP)] screen appears.
③ Set [PROTOCOL 1] to "MULTIDROP".
④ Set [PROTOCOL 2] to "DUPLEX".
⑤ Set the [MACHINE ID] item according to the number of the
RM-P2580[VIDEO INPUT] terminal on each camera.
⑥ Press the [MENU] button to exit setting.
⑦ Turn off and on the power.
Turn off the power of the device to be used.
Memo
Refer also to the instruction manual of the device to be
used.
For details on the type of connection cable and distance,
refer to "Power Supply Connection" (A page 22).
Control signal cables do not support loop connection.
Memo
+ +
- -
RX RX TX TX
Connect the cables correctly such
A B C D
that the A,B, C, D marks of the
camera terminals coincide with those
TO CAMERA DATA I / O
RX+ RX- TX+ TX- COM 1 2 3 4 5 6 7 8 COM 9/1 10/2 11/3 12/4 13/5 14/6 15/7 16/8 COM AUTO UNIT ALARM COM CAMERA SW COM SERIAL-1 SERIAL-2
VIDEO INPUT
1 2 3 4 5 6 7 8
MONITOR MONITOR
OUTPUT OUTPUT
1 2
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
ON VIDEO OUTPUT
of the RM-P2580 terminals.
RM-P2580
Connection/Installation
E-19