Clean Brewing Unit - Bosch TES 71321 Gebrauchsanleitung

en
Simple troubleshooting
Problem
Coffee is too "bitter".
Display shows
Error
Please contact
hotline
The water filter does not
stay in position in the water
tank 11.
Display shows
Check water tank
The coffee grounds are not
compact and are too wet.
Display shows

Clean brewing unit

Coffee or milk froth quality
varies considerably.
Water dripped onto the inner
floor of the appliance when
the drip tray was removed.
If you are unable to solve the problem, please call the hotline!
You will ind the telephone numbers at the back of these instructions.
TES713_H1.indb 51
Cause
The grinding setting is too
ine or the pre-ground coffee
is too ine.
Unsuitable type of coffee.
The appliance has a fault.
The water filter is not mount-
ed correctly.
Water tank has been in-
correctly inserted or the
new water ilter has not
been rinsed according to
instructions.
The grinding setting is too
fine or too coarse, or not
enough ground coffee has
been used.
Brewing unit is soiled.
Too much pre-ground coffee
in the brewing unit.
The brewing unit's
mechanism is stiff.
Build-up of limescale in the
appliance.
Drip tray removed too early. Wait a few seconds after the
Solution
Adjust the grinding unit to a
coarser setting or use coars-
er pre-ground coffee.
Change type of coffee used.
Please call the hotline.
Firmly press the water filter
straight down into the tank
connection.
Insert the water tank cor-
rectly or rinse the water ilter
according to instructions and
then switch on.
Adjust the grinding unit to
a coarser or finer setting,
or use 2 level measuring
spoons of ground coffee.
Clean brewing unit.
Clean brewing unit.
(Pour in no more than 2
level measuring spoons of
ground coffee).
Clean brewing unit (see
"Maintenance and daily
cleaning").
Descale the appliance with
two descaling tablets as de-
scribed in the instructions.
last drink was dispensed be-
fore removing the drip tray.
TES713 | 04/2012
25.04.2012 18:56:47
51 51