Oven Light; Replacing The Light Bulb - Atag SX 111 M Bedienungsanleitung

maintenance

oven light

replacing the light bulb

light bulb: 15 W;
300 °C; 220/240 V;
fitting E14.
Take care: Switch the appliance off first before you touch the
light bulb. The light bulb is at the rear right of the oven (see
illustration).
1 Turn the protective cover a quarter turn to the left.
2 Unscrew the light bulb.
3 Replace the light bulb.
4 Put the protective cover back again.
Make sure that the seals are in the correct place.
GB 12
*
*
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
fault cause
Level-indicator blinks even The reservoir has not been
when reservoir is full. fitted correctly.
The detection system is
defective.
Display does not light up No power supply.
when one of the six control
buttons has been pressed.
Fuse in the meter cupboard
defective.
Electronics defective.
Oven light not on. Appliance not switched on.
Light bulb defective.
No power supply.
Fuse in the meter cupboard
defective.
Water or steam leaks from Door not closed properly.
oven.
Door seal defective.
Irregular buzzing noise You can hear the pump.
during cooking.
faults
what should I do if...
solution
Fit the reservoir correctly.
Phone the service
department.
Put the plug into the
socket.
Replace the fuse.
Phone the service
department.
Switch the appliance on.
Switch oven off and replace
the light bulb.
Put the plug in the socket.
Replace the fuse.
Close the door correctly.
Phone the service
department.
This is normal.
GB 13