Herunterladen Inhalt Inhalt Diese Seite drucken

Observe Room Temperature; Installing The Appliance; Connecting The Appliance - NEFF K8341X0 Gebrauchsanleitung

Inhaltsverzeichnis

Werbung

Observe room
temperature
The appliance is designed for a specific
climatic class. Irrespective of the climatic
class, the appliance can be operated at
the following room temperatures.
The climatic class can be found on the
rating plate at the bottom left hand side
in the appliance.
Climatic class
SN
N
ST
T
Ventilation
Fig. 1/24
Conduction of the heated air must not be
obstructed. Otherwise, the refrigerating
unit must work harder. This increases
power consumption.
Therefore: Never cover or block ventilation
opening!

Installing the appliance

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
30 cm to an oil or solid fuel cooker.
Ambient temperature
+10 °C to 32 °C
+16 °C to 32 °C
+16 °C to 38 °C
+16 °C to 43 °C
Connecting
the appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into
the refrigeration system.
Before switching on the appliance for
the first time, clean the interior of the
appliance (see chapter Cleaning).
The socket should be freely accessible.
Connect the appliance only to
220 240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
to 16 A fuse.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indicated
voltage and current type correspond
to the values of your mains supply.
The rating plate is situated in the bottom
left hand side of the appliance. The power
cord may be replaced by a technician
only.
Warning
!
Never connect the appliance to elec
tronic energy saver plugs or to power
inverters which convert the direct current
to 230 V alternating current (e.g. solar
equipment, power supplies on ships).
en
25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis