Cleaning And Maintenance - Philips Azur GC4043 Bedienungsanleitung

ENGLISH
8
Auto-shut-off (Type GC4043, GC4040, GC4038, GC4035,
GC4033, GC4030)
C
1 An electronic safety device will automatically switch off the
iron if it has not been moved for a while.
To indicate that the iron has been switched off, the red auto-off
pilot light will start blinking.
To heat up the iron again:
- Pick up the iron or move it slightly.
- The red auto-off pilot light will go out.The amber temperature pilot
light may come on, depending on the soleplate temperature.
- If the amber pilot light comes on after the iron is moved, wait for it
to go out before start ironing.
- If the amber pilot light does not come on after the iron is moved, the
iron is ready for use.

Cleaning and maintenance

Calc-Clean
This is a Calc-Cleaning function which removes scale and impurities.
Use the Calc-Clean function once every two weeks. If the water in
your area is very hard (when flakes coming out from the soleplate
during ironing), the Calc-Clean function should be used more
frequently.
1 Set the steam control to position O.
2 Fill the water tank to the maximum level.
Do not use vinegar or other descaling agents.
C
3 Set the temperature control to MAX.
4 Put the plug in the wall socket.
5 Unplug the iron when the amber pilot light has gone out.
C
6 Hold the iron over the sink, press and hold the calc-clean
button and gently shake the iron.
Steam and boiling water will come out of the soleplate. Impurities and
B
flakes (if any) will be flushed out.
7 Release the Calc-Clean button as soon as all the water in the
tank has been used up.