Emptying And Storing The Iron - Melissa 16390038 Gebrauchsanweisung

CLEANING
While the soleplate is still just warm, clean it by rubbing it with a moist non-
metallic pad.
To remove or clean starch or other materials from the ironing surface, apply a
small amount of mild cleaner to a damp cloth forming a paste on the cloth.
Gently rub ironing surface of iron, then wipe with moist cloth. Never use
metallic pads.
Make sure that the iron is completely cooled before cleaning starts.
CAUTION
Never use scouring pads, abrasive or harsh cleaners as this may scratch the
surface.

EMPTYING AND STORING THE IRON

- The iron must be unplugged before emptying. Do not store the iron with
water in the tank.
- Tip the iron over to allow the water to run out. Press the trigger a few times
to ensure all the water is emptied out.
- Always store the iron standing on its heel, with the steam control knob in
MIN position.
SEFL-CLEAN FUNCTION
Regularly clean the steam iron depending on the frequency of use and the local
water quality. In case of rather hard water self-cleaning is recommended at least
every two weeks.
1. Set the steam regulation button (a) to - (steam off).
2. Set the temperature regulating button ( f ) to the highest level.
3. Open the spout for water filling ( j ) and fill water up to the maximum filling mark
into the water tank (g). Close the spout for water filling ( j ).
4. Connect the power plug of the iron to the wall socket.
5. Let the iron heat up until the temperature thermostatic lamp (d )goes out.
6. Disconnect the power plug.
7. Hold the iron horizontally across a sink.
8. Set the steam regulation button (a) to self clean, then pull out the steam
regulation button (a). Boiling hot water and steam come out of the soleplate ( h )
washing out any lime scale. Sway the iron to and fro during this.
9. Set back the steam regulation button (a) to - (steam off).
10. Wipe the soleplate ( h ) on a (preferably) old piece of cloth. Connect the power
plug to the wall socket again and let it heat up. Any residual water now evapo-
rates through the soleplate ( h ).
11. Unplug the appliance and let it cool down before stowing it away.
FOR UNITED KINGDOM ONLY
Plug wiring:
This product is fitted with a BS 1363 13-amp plug. If you have to replace the
fuse, only those that are ASTA or BSI approved to BS1362 and with a rated
current of 13 amps should be used. If there is a fuse cover fitted, this cover
must be refitted after changing the fuse.
If the fuse cover is lost or damaged, the plug must not be used. You must also
check if the socket outlets in your home fit with the plug of the appliance. If
the socket outlet in your home does not fit with the plug, the plug must be
removed and disposed of safely as insertion of the plug into the socket is
likely to cause electric hazard. A replacement plug should be wired according
to following description.
21