5....-06-DO 2852
GB
•
Read the operating instructions carefully before putting the appliance into ope-
ration and keep the instructions including the warranty, the receipt and, if possi-
ble, the box with the internal packing.
•
The appliance is designed exclusively for private use and for the envisaged pur-
pose. This appliance is not fit for commercial use. Do not use it outdoors
(except if it is designed to be used outdoors). Keep it away from sources of
heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do
not use the appliance with wet hands. If the appliance is humid or wet, unplug it
immediately. Do not put it in water.
•
When cleaning or putting it away, switch off the appliance and always pull out
the plug from the socket (pull on the plug, not the cable) if the appliance is not
being used and remove the attached accessories.
•
Do not operate the machine without supervision. If you should leave the work-
place, always switch the machine off or remove the plug from the socket (pull
the plug itself, not the lead).
•
To protect children from the dangers posed by electrical appliances, make sure
that the cable is hanging low and that children do not have access to the appli-
ance.
•
Check the appliance and the cable for damage on a regular basis. Do not use
the appliance if it is damaged.
•
Do not try to repair the appliance on your own. Always contact an authorized
technician. To avoid the exposure to danger, always have a faulty cable be
replaced only by the manufacturer, by our customer service or by a qualified
person and with a cable of the same type.
•
Use only original spare parts.
•
Pay careful attention to the following "Special Safety Instructions".
1
Type plate
2
Housing
3
Connection cable with mains plug
4
Cutting lever
Connection
•
The mains voltage must correspond to the voltage stated on the type plate of
the tin opener.
•
Connect the device to a correctly installed 230 V, 50 Hz shockproof socket.
28
13.04.2004
12:37 Uhr
General Safety Instructions
Controls
Initial Operation
Seite 28
5
Adhesive magnet
6
Cutting blade
7
Transport wheel
8
Pushbutton