Altering The Playing Speed; Transport - MC Crypt DJ-2650D 30 16 44 Bedienungsanleitung

Operation
• To stop the playback or if the end of the record has been reached lift the pick-up
levering the pick-up arm lift (15) (Open-Position) and then place the pick-up arm (13) back onto the pick-up arm
rest (14). Lower the pick-up arm (13) so that it can rest in a stabile position on the pick-up arm rest (14).
• Operate the START/STOP button (6) or press Start/Stop on the remote control (mixing desk). The record play-
er is then turned off.
• When yon have finished operation first switch the amplifier off and then the record player using the POWER
button (5).
Adjusting the playing pitch speed
The playing pitch speed can be adjusted using the speed
• Sliding the speed regulator (12) upwards reduces the playing speed, sliding it downwards increases the playing
speed.
• only for model DJ-2650D:
If the original speed of the record player has not been altered the LED display on the speed regulator (12)
green, if the speed has been altered then it is red.
When the pick-up arm is not in
firmly in place, to prevent any unnecessary damage. Please make sure before locking the pick-
up (13) into position that the pick-up lift (15) is fully lowered.
To protect this appliance from dust close the lid carefully during playback or after use.
The single adaptor puck when not in use should be returned to the single puck holder (1).
A spare pick-up system together with the system carrier can be clipped into the spare pick-up system holder (18).
Thus storing it in a safe place where it can be instantly installed when needed.

Transport

• Disconnect the mains cable, pull out the cinch cables and unscrew the earthing cable
• Secure the pick-up arm (13) with the rest clip.
• Put the protective plastic covering over the system needle.
• Remove the pick-up system head (9).
• Remove the pick-up arm counterweight (17).
• Remove the turntable (2).
• Remove the lid.
• Pack the appliance back into its original packing.
32
arm (13) from the record, by
regulator (12) resulting in a higher or lower tone effect.
use (13) always return it to the pick-up arm rest (14) with the clip
Montage
Plateau tourne-disque
Modèle DJ-2650D :
• Emboîter le plateau du tourne-disque (2) sur l'axe du tourne-disque (3).
• Placer la natte fournie avec l'appareil sur le plateau du tourne-disque (2).
Modèle DJ-2650B :
• Emboîter le plateau du tourne-disque (2) sur l'axe du tourne-disque (3).
• Tourner le plateau du tourne-disque jusqu'à ce que l'axe d'entraînement du moteur devienne visible sous l'un
des deux trous carrés du plateau du tourne-disque.
• Placer la courroie d'entraînement qui se trouve sur le côté inférieur du plateau du tourne-disque, au-dessus de
l'axe d'entraînement du moteur.
is
• Placer la natte fournie avec l'appareil sur le plateau du tourne-disque (2).
Capot
• Placer le cache de protection dans la charnière du cache de protection (19)
41