Trouble Shooting - Zipper ZI-TKS250H Bedienungsanleitung

16

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
PROBLEM
Excess vibration
Rip fence does not
move smoothly．
Rip fence does not
lock at rear．
Cutting binds or
burns work．
Wood edges away
from rip fence when
ripping．
Saw does not make
accurate 90ºor 45º
cuts．
Height/bevel
adjusting handwheel
is hard to turn．
Saw does not start．
Blade makes poor
cuts．
Blade does not lower
when turning height
/bevel adjusting
handwheel．
Motor labors in rip
cut．
MANY POTENTIAL
CONNECTION TO THE ELECTRICITY GRID.
ZIPPER MASCHINEN GmbH
TISCHKREISSÄGE / TABLE SAW
Blade is out balance．
Blade is damaged．
Saw is not mounted securely．
Work surface is uneven．
Blade is warped．
Rip fence not mounted correctly．
Rails are dirty or sticky．
Clamp screw is out of adjustment．
Clamp screw is out of adjustment．
Blade is dull．
Working is fed too fast．
Rip fence is misaligned．
Spreader is out of alignment．
Wood is warped．
Ripping fence is misaligned．
Positive stops inside cabinet need
adjusting(Bevel Cuts)．
Miter gauge is misaligned(Miter Cuts) ．
Gears or post inside cabinet are clogged
with saw dust．
Motor cord or wall cord is not plugged
in．
Circuit fuse is blown．
Circuit breaker is tripped．
Cord or switch is damaged．
Blade is dull or dirty．
Blade is wrong type for cut being made．
Blade is mounted backwards．
Locking lever is not at full left position．
Blade not proper for rip out．
SOURCES OF
www.Zipper-Maschinen.at
ZI-TKS 250H / ZI-TKS 250-2VBite 33
CAUSE
ERROR CAN BE
TROUBLE SHOOTING
SOLUTION
Replace blade．
Replace blade．
Tighten all hardware．
Reposition on flat surface．
Replace blade．
Remount the rip fence．
Clean and wax rails．
Adjust clamp screw．
Adjust clamp screw．
Replace or sharpen blade．
Slow the feed rate．
Align the rip fence．
Replace the wood．Always cut with
convex side to table surface．
Check and adjust the rip fence．
Adjust positive stops．
Adjust the miter gauge．
Clean the gears or screw post．
Plug in motor cord or wall cord．
Replace circuit fuse．
Reset circuit breaker．
Have the cord or switch replaced．
Clean, sharpen, or replace blade．
Replace with correct type．
Remount blade．
Move locking lever to left．
Change blade; rip blade typically has
fewer teeth．
CLEARED BY THE EXPERTLY
Seite 33