Rear Panel - Hartke HA3500 Bedienungsanleitung

Guided Tour - Model 3500/5500 Rear Panel
Hartke Systems
Distributed Exclusively by
Samson Technologies Corp.
Hicksville, New York 11802
MODEL 5500 ~ AC INPUT
350 WATTS 115V/230V 50/60Hz
FUSE
8 = 350 WATTS
10A/250V, 300W (115V)
4 = 500 WATTS
6.2A/250V, 740W (230V)
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER
SERVICEABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL. TO
PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE TO RAIN OR MOISTURE.
ASSEMBLED
SERIAL NUMBER
IN R.O.K.
1 4
3
SPEAKER
OUTPUTS
8Ω
8Ω
2 3
1. Fuse sled - This contains a fuse holder and shows the currently selected
voltage rating for your Model 3500/5500. Make sure the voltage rating is cor-
rectly set before powering up the amplifier! Fuse ratings are 10 amp for 115
vac and 6.2 amp for 230 vac. For information on how to change the voltage
rating, see Appendix B on page 14.
2. AC input - Connect the supplied standard 3-pin "IEC" plug here.
3. Speaker outputs - Connect any 4, 8, or 16 ohm bass cabinet(s) to these
standard unbalanced 1/4" jacks. WARNING: Because of the high power levels
and low frequency content of the signal generated by the Model 3500/5500,
use only appropriately rated speaker cabinets (at least 600 watts at 4 ohms)
that are specifically designed for bass instruments. We recommend that
Hartke amplifiers be used with Hartke bass cabinets, although other brands of
speakers can be used.
4. Fan - The fan provides vital cooling to your Model 3500/5500. Make sure
that it is kept free of all obstructions and that cool, fresh air is accessible at all
times. Also, try to ensure that the Model 3500/5500 is used in a dust-free
environment.
5 8 9
EFFECT DIRECT OUT
POST NORMAL
SEND
PRE GND LIFT
RETURN BALANCE
0
SEND RETURN
6 7 10
6 6