Specified Conditions Of Use; User Groups - Weller WTSF 120 Originalbetriebsanleitung

Warning! Fire and explosion hazard!
Hot tools represent a fire hazard
Always place the soldering tool in the safety rest while not in use.
„
Keep explosive and flammable objects well away from the device.
„
Do not cover the device.
„
Warning! Danger of injury
Uncontrolled solder wire feed can cause injury.
Wear protective goggles
„
Wear gloves!
„
Only use the solder wires recommended in the operating instructions
„
Warning! Danger of injury
The device or parts of the device may fall off during transportation.

Specified Conditions Of Use

The solder wire feed system many only be used
for the soldering of parts.
Operate the device only in combination with the
following supply units:
WTSF 80: WD 1
WSD 81
WSD 81i
WS 81
WXSF 120: WX 1
WX 2
WXD 2
WXA 2
WXR 3

User groups

Due to differing degrees of risk and potential hazards, several work steps may only be performed by
trained experts.
Work step
Maintenance
Replacing electrical replacement parts
Default maintenance intervals
Operation
Replace solder wire
Operation
Maintenance
Replace solder wire
Replacing electrical replacement parts
22
WTSF 80 + 120: WD 1M
WSD 121
WR 2
WR 3M
Only use the device indoors. Protect against mois-
ture and direct sunlight.
Intended use of the soldering station/ desoldering
station also includes the requirement that you
adhere to these instructions,
„
observe all other accompanying documents,
„
comply with national accident prevention
„
guidelines applicable at the place of use.
The manufacturer will not be liable for unautho-
rised modifications to the device.
User groups
Specialist personnel with technical training
Electricians
Safety expert
Non-specialists
Technical trainees under the guidance and supervision
of a trained expert