Directional Control - Carrier 42QHP12E8S-series Bedienungsanleitung

2. OPERATION

2.4 Directional Control

Adjusting vertical air flow
● Press "SWING(vertical air flow)" on remote controller to adjust
vertical air flow direction. The louver position moves slightly each
time the button is pressed.
● Press "SWING(vertical air flow)" to
engage continuous louver motion.
Adjusting horizontal air flow
● Press "SWING(horizontal air
flow)" on remote controller to
adjust vertical air flow direction.
The louver position moves slightly
each time the button is pressed.
● Press "SWING(horizontal air
flow)" to engage continuous
louver motion.
Note: Please refer to the REMOTE CONTROLLER MANUAL for details.
Intelligent Eye Operation
Press the Intelligent eye button on the remote control
to select wind flow follow people feature or wind flow
away from people feature.
The intelligent eye can detect people's activities in
the room and adjust the horizontal angle of air flow to
implement the features.
NOTE: The wind flow follow people feature is only
available for a single people area. If press the SWING
button on the remote control, this feature will stops
automatically.
Louver position
Maximum down
In COOLING or DRY
mode, condensate may
form and drip from unit in high humidity
condition.
Narrow opening
Restricted air flow reduces performance and
may cause condensate.
Closed
Do not operate if it will not open – damage
may occur.
Louver action
After a quick restart, louver may remain
static for about 10s.
09
WARNING!
Do not put your fingers in or near the
blower and suction side of the unit.
The high-speed fan inside the unit
may cause injury.
Do not move louver by hand. This
will cause the ouver to become out of
sync. If this occurs, turn off the unit
and unplug it for a few seconds,then
restart the unit. This will reset the
louver.
Air conditioner
Intelligent eye
Detectable area
The detectable range is
varied according to the
room temperature.
Features (Model dependent)
CAUTION
■ Auto swing of horizontal air flow*
● Press "SWING" for two secends to
engage vertical blades swing motion.
Note: Please refer to the REMOTE
CONTROLLER MANUAL for details.
■ Louver Memory*
Horizontal louver angle is memorised and
will return to the position last selected by the
user.
This will not happen in TURBO mode,
running by manual control buttons, or after a
power interruption.
wall
Left
(75° ± 10°)
1m (30° ± 10°)
8m
For example:
Detectable area at 25 °C.
Right (75° ± 10°)
Middle