Setup; Dmx512 Connection; Connection To The Mains; Sound Control - EuroLite Color Chief 700064575 Bedienungsanleitung

12 MENU/ESC button
13 DEL button
14 SWAP button
15 ENTER button
16 Display
17 Encoder wheel
18 CHASES 1 to 24
button group
19 STORE button
20 FADE TIME fader
21 CHASE SPEED fader
22 MASTER fader
23 USB port
24 Audio input
25 DMX512 output
26 Power input
27 Power on/off

DMX512 connection

Use a DMX cable and 3-pin XLR plugs and connectors in order to connect the foot switch to the DMX chain. If you
wish to connect fixtures with other XLR outputs, you need to use adapter cables.
1 Connect the DMX output of the controller to the DMX input of the first light effect unit.
2 Connect the DMX output of the first fixture in the DMX chain to the DMX input of the next fixture. Always
connect one output to the input of the next fixture until all fixtures are connected.
3 At the last fixture, the DMX cable has to be terminated with a terminator. For this solder a 120 Ω resistor
between signal (–) and signal (+) into a 3-pin XLR plug and plug it in the DMX output of the last fixture.
4 If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended to
insert a DMX level amplifier to ensure proper data transmission.

Connection to the mains

Connect the power adapter provided to the corresponding input on the controller and to a mains socket. After the
operation, disconnect the mains plug unit from the socket, to prevent unnecessary power consumption.

Sound control

For sound-controlled run of a chase it is possible to connect an audio unit with line output (e.g. CD player, mixer)
to the jack AUDIO (sensitivity 0.1-1 V). When connecting the audio unit to the jack, the internal microphone is
switched off.
Keep this button pressed for 3 seconds in order to call or exit the system
settings. Shortly press the button to abort a setting procedure and go
back to a higher menu level.
To delete a DMX function during configuration of the controller.
To switch between menu items.
To confirm settings.
Indicates the settings currently made and other important information.
To adjust values.
To memorize and call scenes and chases.
To memorize a setting.
To adjust the fade time of chases.
To adjust the running speed of chases.
To adjust the overall brightness.
For connecting a USB flash drive for storing and importing data and
firmware updates.
RCA jack for connecting an audio device with Line output (e.g. mixer) to
control the run of a chase to the rhythm of the music; when connecting
the jack the internal microphone is switched off.
3-pin XLR jack for connecting the DMX input of the first light effect unit.
Connect the power adapter provided here.
Switches the controller on and off.

SETUP

25 • EN