Product Information - Hilti SID 8-A22 Original Bedienungsanleitung

1 Information about the documentation
1.1 Conventions
1.1.1 Warning signs
The following warning signs are used:
General warning
1.1.2 Symbols
The following symbols are used:
Read the operating instructions before use.
Instructions for use and other useful information
Rated speed under no load
Revolutions per minute
Revolutions per minute
1.1.3 Typographic emphasis
The following typographic features are used to emphasize important passages in the technical documentation
about your impact screwdriver:
1 These numbers refer to the corresponding illustrations.
1.2 Operating instructions
▶ It is essential that the operating instructions are read before initial operation.
▶ Always keep these operating instructions together with the tool.
▶ Ensure that the operating instructions are with the tool when it is given to other persons.
Changes and errors excepted.

1.3 Product information

▶ The type designation and serial number can be found on the type identification plate on the tool. Make
a note of this data in the following table and always refer to it when making an enquiry to your Hilti
representative or Hilti Service Center.
Product information
Type:
Generation:
Serial no.:
2 Safety
2.1 Warnings
The purpose of warnings
Warnings alert persons to hazards that occur when handling or using the product.
Description of the key words used
DANGER
Draws attention to imminent danger that will lead to serious personal injury or fatality.
WARNING
Draws attention to a potentially dangerous situation that could lead to serious personal injury or fatality.
Printed: 20.05.2015 | Doc-Nr: PUB / 5230112 / 000 / 00
01
11