Connectors; Stand Flange - LD Systems LDEB82G3 Bedienungsanleitung

All Stinger G3 enclosures are made of rigid, low-resonance birch ply. They are coated with non-abrasive, impact resistant
®
polyurea for superior strength and unrivaled durability. Integrating LD Systems' Dual-Tilt pole mount, multiple suspension
points, stacking recesses and ergonomic handles the Stinger
companies and installation applications. The large selection of Stinger
hardware plus a stackable dolly board to facilitate transport. Isn't it time you saddled up?

CONNECTORS

1 INPUT
Input with Speakon-compatible speaker socket (assignment 1+, 1-). The INPUT and OUTPUT sockets are wired in parallel (2+ 2- are not
used). The speaker has an impedance of 8 ohms.
2
OUTPUT
Output with Speakon-compatible speaker socket (assignment 1+, 1-). When routing the signal, please be aware of the total impedance of
the system to prevent any damage to the amplifier.

STAND FLANGE

The speakers have a stand flange with a 0° angle socket (rear position) and a socket with a 5° tilt angle (front position). Examples of use:
Use the socket with the 0° angle for standing audiences and the socket with the 5° tilt angle for seated audiences.
G3 Series has been designed for touring musicians, rental
®
accessories includes smart wall and truss mounting
®
1
2
5