Basic Operation; Receiving And Transmitting; Call-Ring Operation; Smart-Ring Operation - Icom PMR446 Basis Bedienungsanleitung

■ Receiving and Transmitting

Receiving
1. Rotate [Rotary Selector] to select a channel.
2. When receiving a call, rotate [VOL] to adjust the audio.
Transmitting
Wait until the channel is clear to avoid interference.
1. While holding down [PTT], speak at your normal voice
level.
2. Release [PTT] to receive.
NOTE: To insure the readability of your signal:
1. After pushing [PTT], pause briefly before you start
speaking.
2. Hold the microphone 5 to 10 cm from your mouth, and
then speak at your normal voice level.

■ Call-Ring operation

This function sends the preset ringer to your group members.
NOTE: To use this function, the operating channel and
CTCSS tone must be the same on all of your group
transceivers.
Hold down [Upper] for 1 second to send the preset ringer.
• The ringer sounds while holding down [Upper].
• The same ringer sounds from your group members' speaker.

BASIC OPERATION

■ Smart-Ring operation

This function has an answer back call feature. You can
confirm whether or not a call has reached your group
members, even if the operators are temporarily away from
their transceivers.
The called transceivers automatically send an answer back
call to your transceiver.
NOTE: To use this function, the operating channel and
CTCSS tone must be the same on all of your group
transceivers.
1. Push [Upper] to make a Smart-Ring call.
• When an answer back call is received, the transceiver sounds
beeps and the LED indicator blinks orange.
- Turn OFF the transceiver to stop the beeps and the LED
blinking.
• When no answer back call is received, the transceiver sounds
three short failure beeps.
2. Push [PTT] to answer the call and stop the beeps and
blinking.
2
6