Aesculap Exacta Originalbetriebsanleitung Seite 16

Damage to casing when screwing on
clipper head!
Do not over tighten the screw.
WARNING
16
Make sure the On/Off switch 4
is in the 0 position.
Remove the Allen key 13 from
the base of the charging unit
and use it to loosen the blade
set screw 6.
Loosen the screw fully and re-
move it.
Push the blade set upwards with
your thumb.
Push the new blade set on until
it snaps into place and secure it
using the screw.
While the blade set is removed, you can use the
cleaning brush to remove residual hair from inside the
appliance.
Cleaning the appliance
Clean your appliance occasionally with a damp cloth,
then wipe it dry.
Cleaning the charging contacts
If the charging contacts 7 on the appliance or the charg-
ing contacts 3 on the charging unit are dirty, charging
may not be possible or may be interrupted.
Clean the contacts using a cloth or wad of cotton
wool soaked in alcohol or spirit.
Care of the NiMH rechargeable battery
To maintain the charging capacity of the battery we rec-
ommend occasionally draining the battery until the mo-
tor stops.