Shure PSM 900 Bedienungsanleitung Seite 7

P9T Rack Unit Transmitter
level L R
CLIP
Front Panel Controls
① Input Level Control and Display Use the ▼▲ buttons to adjust the
audio so that, for the average input signal level, the top two yellow LEDs
flicker and the lower LEDs are solid. The red clip LED indicates the inputs
are overdriven. Reduce the level at the audio source or change the input
sensitivity of the rack unit from the AUDIO>INPUT menu.
② Status Display and Menu Controls Use the enter and exit buttons
and the menu wheel to access the configuration menu. Push the menu
wheel to move the cursor to the next item. Turn the menu wheel to change
a parameter—the enter button flashes. Press it to save the value. Press
the exit button to cancel changes and return to the previous menu.
③ Synchronization Button Press the sync button while rack unit and
bodypack IR windows are aligned to transfer settings.
④ Headphone Monitoring The volume control adjusts signal output to
the 3.5 mm headphone jack. NOTE: it does not affect rear panel outputs.
⑤ RF switch mutes RF output. For setting up multiple systems or
adjusting settings without transmitting unwanted RF or audio signals.
⑥ Power Button Turns the unit on and off.
Rear Panel Connectors
⑦ Power Connect the transmitter to a power outlet using the supplied
power adapter.
⑧ LOOP OUT Sends a copy of the audio signal going into the transmitter
to another device. See LOOP Applications.
⑨ Audio Inputs Connect to balanced or unbalanced outputs. Use either
connector for mono input. Accepts both 1/4-inch or male XLR connectors.
⑩ Antenna (BNC) Attach supplied antenna. If you are rack mounting, use
a front panel or remote mounting kit from Shure.
menu sync volume power
sync
RF Settings
RADIO
G
Sets the group number
CH
Sets the channel number
888.888MHz
Manual frequency selection
RF POWER
Select from 10, 50, or 100 mW (varies by region)
Audio Settings
AUDIO
MODE
Selects monitor mode
STEREO/MX
MONO
INPUT
Sets nominal input level
LINE +4 dBu
AUX –10dBV
Utilities and Display Settings
UTILITIES
EDIT NAME
Changes the name on the LCD display (this name is
uploaded to the bodypack with sync)
DISPLAY
Changes the display format
CONTRAST
Changes the display contrast
LOCK PANEL
Locks front panel controls. To unlock, press exit,
select OFF, and press enter.
MENU+LEVEL
MENU ONLY
MENU+SWITCH
ALL
*RF is automatically activated when locked. When
you unlock the unit, RF and power turns off if the
switches are off.
RX SETUP
These settings are sent to the bodypack during a
sync (when the sync direction is from the transmit-
ter). The default KEEP parameter will not change the
bodypack settings.
LOCK
V LIMIT
LIM VAL
MODE
BAL MX
BAL ST
HIBOOST
CUSTOM GROUP
For creating custom frequency groups
RESET SYSTEM
Returns all settings to the factory defaults.
NO
YES
Transmits both channels
Transmits a mono signal to
bodypack
line level
aux level
Locks menu and level
controls.
Locks only the configuration
menu (menu controls).
Locks all controls except for
the level buttons (including the
RF and power switches).*
Locks all controls (including the
RF and power switches).*
Lock bodypack
Volume limiter
Volume limiter value
Stereo (ST) or MixMode (MX)
CH. 1 (L) and CH. 2 (R) mix for
MixMode
Left (L) and right (R) balance
for stereo mode
high frequency boost
Exit and do not reset system.
Reset system settings.
3