PIONEER DJ dm-40bt Bedienungsanleitung Seite 6

Rear panel
1 INPUT 1 terminals (stereo)
These are RCA pin type unbalanced input terminals.
2 INPUT 2 terminals (stereo)
This is a 3.5 mm stereo mini plug type unbalanced input terminal.
3 Speaker connection connectors
Connect the left and right speakers using the included cord.
Do not connect these speakers to an amplifier other than that of this
system. Doing so may cause a damage or fire.
4 POWER switch
Turns this unit's power on and off.
5 AC IN
Connect the power cord to AC IN and then to the power outlet.
Connect the power cord after all the connections between devices
have been completed.
Be sure to use the included power cord.
6
En
1
2
3
4
5
CAUTION
The POWER switch on this unit will not completely
shut off all power from the AC outlet. Since the power
cord serves as the main disconnect device for the
unit, you will need to unplug it from the AC outlet to
shut down all power. Therefore, make sure the unit
has been installed so that the power cord can be
easily unplugged from the AC outlet in case of an
accident. To avoid fire hazard, the power cord should
also be unplugged from the AC outlet when left
unused for a long period of time (for example, when
on vacation).
CAUTION
! This product is provided with an auto standby function. If a
state of no sound continues for a set time (approximately 30
minutes) during use, the product automatically turns off the
POWER indicator and enters a standby state with low power
consumption regardless of whether there is a Bluetooth
connection.
! If the product enters the standby state when there is
a Bluetooth connection, the Bluetooth connection is
disconnected and the Bluetooth indicator also turns off.
! When an audio signal is input from the input terminals in the
standby state, the product automatically enters the power-on
state. Furthermore, the product also enters the power-on state
if the Bluetooth pairing button is pressed while in standby.
! This auto standby function cannot be disabled.
D3-4-2-2-2a*_A1_En