Operating Bianco Diver - bianco diver Bedienungsanleitung

Operating BIANCO diver

Connect your BIANCO diver to a power socket with the correct electric specifications. You can find them on the type plate
at the back side of the device and in chapter „Technical Data" on page 32. Please make sure that the power plug is properly
inserted into the power socket.
Start-up
In order to use your BIANCO diver, it is necessary to place on the mixing container on the motor block properly. Without a
mixing container, your BIANCO diver does not start. If you put the container on the engine block, you will hear a long beep
and the display as well as the buttons light up briefly. Now, your BIANCO diver is in energy saving mode.
Energy Saving Mode
1
When the mixing container is placed on the motor block, the display illuminates blue and the On/Off button lights up red
(Fig [10] page 1). In order to get your BIANCO diver into standby mode, press any key on the keypad (page 11). This is
confirmed by a short beep. Now, all buttons on the control panel are lit. Your BIANCO diver is now in Standby Mode.
Standby Mode
In Standby Mode, the display shows "00:00" and the speed level is set to 3 . All symbols on the control panel are lit and the
On/Off button flashes red. Now you can use the preset programmes (→ page 14) or the Manual Mode (→ page 16) of your
BIANCO diver.
Your BIANCO diver automatically changes to Energy Saving Mode after 30 seconds of inactivity.
1
Power consumption in Energy Saving Mode: 0,339 Watt
EN
13