Rear Panel - Akai Professional MPCLIVE Schnellstartanleitung

Rear Panel

13 13 13
8
14
1. Power Input: Use the included power adapter to connect MPC Live to a power outlet.
Alternatively, you can power MPC Live via the USB port only, but the display will be disabled.
2. Power Switch: Turns MPC Live's power on/off.
3. Charging Indicator: This light (behind the vent) will turn on when MPC Live's internal battery is
charging (when the power input is connected to a power outlet). When the battery is fully
charged or when it is disconnected from a power outlet, then this light will turn off.
4. USB-B Port: Use the included USB cable to connect this high-retention-force USB port to an
available USB port on your computer. This connection allows MPC Live to send/receive MIDI
and audio data to/from the MPC software on your computer.
You can power MPC Live via the USB port only, but the display will be disabled.
5. USB-A Ports: Connect USB flash drives to these USB ports to access their files directly using
MPC Live.
6. SD Card Slot: Insert a standard SD/SDHC card into this slot to access its files directly using
MPC Live.
7. Rec Vol: Turn this knob to adjust the volume of the inputs.
8. Master Vol: Turn this knob to adjust the volume of the outputs and phones output.
9. Inputs (1/4" / 6.35 mm): Use standard 1/4" (6.35 mm) TRS cables to connect these inputs to an
audio source (mixer, synthesizer, drum machine, etc.). In Sample Record Mode, you can select
whether you want to record either channel or both channels in stereo or in mono. To use these
inputs, set the Line/Phono switch to Line.
10. Inputs (RCA): Use a standard RCA stereo cable to connect these inputs to a phono-level audio
source like a turntable. In Sample Record Mode, you can select whether you want to record
either channel or both channels in stereo or in mono. To use these inputs, set the Line/Phono
switch to Phono.
11. Line/Phono Switch: Set this switch to the appropriate position, depending on which inputs you
want to use. If you are using the RCA inputs, set this switch to Phono to provide the additional
amplification needed for phono-level signals. If you are using the 1/4" (6.35 mm) inputs, such as
a CD player or sampler, set this switch to Line.
12. Grounding Terminal: If using phono-level turntables with a grounding wire, connect the
grounding wire to these terminals. If you experience a low "hum" or "buzz", this could mean that
your turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore,
nothing needs to be connected to the grounding terminal.
13. Outputs (1/4" / 6.35 mm): Use standard 1/4" (6.35 mm) TRS cables to connect these outputs to
your monitors, mixer, etc.). The Master L/R outputs are the same as Outputs 1,2.
14. Phones (1/8" / 3.5 mm): Connect standard 1/8" (3.5 mm) stereo headphones to this output.
15. MIDI In: Use a standard 5-pin MIDI cable to connect this input to the MIDI output of an external
MIDI device (synthesizer, drum machine, etc.).
16. MIDI Out: Use a standard 5-pin MIDI cable to connect this output to the MIDI input of an
external MIDI device (synthesizer, drum machine, etc.).
®
17. Kensington Lock Slot: You can use this slot to secure your MPC Live to a table or other surface.
17 12
9
10
7
11
6
16
15
5 4 1
3
2
5