Measuring Functions - BURG WATCHER 20 PS 7520 Bedienungsanleitung

Measuring functions

Note: With every successful measurement, with
selecting / abandon a function or with turning on or
off of the device, a short audio signal sounds. If an
error occurs during measuring, this will be indicated
through a longer audio signal.
Measuring distance
Press the button
distance measuring mode is pre-set with every turning
on of the meter and the symbol of distance measuring
to be measured distance and press the measuring
button
display on the bottom line and a short audio signal
sounds. Press the measurement button for another
measuring to activate the laser. Target the end of
the distance and initiate measuring by pressing
the measurement button again. With every new
measuring, the last measured value is displayed one
line above before it will be deleted after three further
measurements. This way, the last three values can be
compared to the current value. With a short pressing
of the button
deleted.
7520 LASER METER 20 PS 7520
CLEAR
appears on the display. Target the end of the about
. The measured value appears on the
MEAS
CLEAR
to turn on the device. The
the respective last value can be
English | 23