Operation; Introduction; The Basic Control Pad; Power On / Off - Optelec ClearView C Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

Optelec

4. Operation

When using the ClearView C, place your hands on the wrist support at the front

of the table for easy access to the Control Pad buttons and for steady table

movement.

The ClearView C is equipped with a wireless Control Pad, located between the

two wrist supports in the reading table. If the Control Pad is placed in the

reading table with the Optelec logo facing you, the ClearView C buttons for the

basic functionality are accessible.

To access the buttons for the advanced functionality, simply rotate the Control

Pad so five rectangular buttons are facing you.

4.2.

The Basic Control Pad is correctly placed in the reading table when the Optelec

logo is facing you, and three large buttons are on top of the Control Pad.

In case the ClearView does not power on, make sure all cables are connected

and that the power switch, located at the left side of the camera box behind the

monitor, is in its ON position.

To power on both the system and monitor, press the orange

round On / Off button located next to the Zoom dial on th e

Control Pad. The ClearView C will start up in the same

viewing mode as when it was powered off.

It takes about 5 seconds for the camera unit to initialize

before it displays an image.

ClearView C

English

Inhaltsverzeichnis