Adding More Ingredients; After You Have Finished Using Your Appliance; Working With Special Accessories - Silvercrest SKV 1200 A1 Bedienungsanleitung

Adding more ingredients

1) Turn the appliance off using the rotary switch
2) Remove the blender lid
ents
or
3) Turn the measuring cup
clockwise as far as it will go and then take it
out. Add the ingredients gradually through the
opening in the blender lid
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch
(Position "0").
2) Turn the blender
symbol on the blender
symbol on the appliance and remove it.
NOTE
► Ideally, you should clean the blender
mediately after use (see the section "Cleaning
and care"). This makes food residues easier
to remove.
3) Place the drive protection cover
the blender drive
the drive protection cover
symbol on the appliance. Turn the drive
protection cover
symbol on the drive protection cover
pointing to the
SKV 1200 A1
and add the ingredi-
in the blender lid
.
clockwise so that the
is pointing to the
back on
so that the symbol on
is pointing to the
anticlockwise so that the
symbol on the appliance.

Working with special accessories

.
NOTE
► The special accessories, such as a meat
grinder attachment, a noodle attachment and
vegetable grater, can be ordered online at
www.kompernass.com.
ATTENTION! PROPERTY DAMAGE!
► The drive unit for special accessories
should only be used for accessories which
are specifically approved for use with this
appliance by the manufacturer.
1) Turn the appliance off using the rotary switch
(Position "0").
2) Push the cover over the drive unit for special
accessories
the appliance.
3) Attach the special accessory to the appliance
in accordance with its operating instructions.
im-
ATTENTION! PROPERTY DAMAGE!
► Never use special accessories at the same
time as the mixing bowl
This will overload the motor!
After you have finished using
your appliance
1) Turn the appliance off using the rotary switch
is
(Position "0").
2) Disconnect the special accessory from the ap-
pliance as stated in its operating instructions.
3) Clean all components as described in the
section "Cleaning and care".
4) Place the cover for the drive unit for special
accessories
upwards and remove it from
or blender
back in position.
GB
!
9 ■
│