5-GLASS INSERTION DIAGRAM
GHOST lamp insertion
•
For this type of outlet ducting is possible only to the right or to the left. The glass insertion mechanism is the same as for the Flip and
Float lamps.
The Ghost lamp outlet support is fitted with an actuator with an extension lead for opening the lamp glass. The actuator must always
be housed above, therefore in the event the support is rotated one must move the actuator into the upper hole. Therefore, for this type
of outlet, one must also make the electrical connections for the actuator (UP TO THE INSTALLER).
The GHOST outlet can only be fitted with one lamp holder with the lamp in the lower position, in the point in which the lamp glass can
be lifted.
ACTUATOR WITH EXTENSION CABLE
GHOST
IMPORTANT!
The fan/lamp connection cable is made of silicone to resist high temperatures. In the event of extension cables (over
2.5 m) and in any case under all circumstances, make sure that the cable does not come into contact with hot parts
of the closed fireplace, or with air connecting pipes within the cladding or structure.
Technical Dept. - All rights reserved - Reproduction is prohibited
LAMP HOLDER + LAMP - TO BE
INSTALLED BELOW
EN
37