Technical Specifications - Parkside PNTS 250 A1 Originalbetriebsanleitung

Technical specifications

Nominal input voltage ......230 V~, 50 Hz
Power consumption ..................... 250 W
Safety class ..........................................
Rotation speed n
wet grinding disc ...... approx. 128 min
dry grinding disc .... approx. 2950 min
Weight (incl. accessories)
Sound pressure level
(L ) ..................... 63 dB (A); K
pA
Sound power level
(L ) .................... 76 dB(A); K
WA
Vibration total value (a
Wet grinding disc
Outer diameter ................... Ø 200 mm
Bore hole ............................. Ø 20 mm
.................................40 mm
Grain size ......................................80
Speed n .................... max. 3820 min
0
Working speed ................
Dry grinding disc
Outer diameter ................... Ø 150 mm
Bore hole .......................... Ø 12.7 mm
.................................20 mm
Grain size ......................................36
Speed n .................... max. 4500 min
0
Working speed ................
* A break is introduced after 30 minutes of
uninterrupted operating duration until the de-
vice temperature differs 2 K (2°C) less than
room temperature.
(S2 30 min)*
..........................
.. approx. 8.6 kg
= 3 dB
pA
= 3 dB
WA
) .......... 2 5
h
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
undertaken in the course of further devel-
2 opment without notice. All dimensions,
references and information in this instruc-
tion manual are therefore not guaranteed.
-1
Legal claims made on the basis of the
-1
instruction manual can therefore not be
considered as valid.
measured in accordance with a standard
testing procedure and may be used to com-
2
pare one power tool to another.
also be used for a preliminary exposure
assessment.
Warning!
-1
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at protect-
ing the user should be based on
estimated exposure under actual
usage conditions (all parts of the
-1
5 operating cycle are to be consid-
ered, including, for example, times
during which the power tool is
turned off and times when the tool
is turned on but is running idle).
G B I E N I
7