ESX QE80 Benutzerhandbuch Seite 33

FUNCTIONAL INSTRUCTIONS
3
1
2
4
CONFIGURATION OF CHANNELS A/B (TWEETER)
1. Choose under SOURCE the setting MAIN.
2. Choose the channel pair A & B under CH SETTING by clicking on the lock symbol.
3. Choose under CROSSOVER > FILTER TYPE the setting HP (highpass filter)
4. Set under CROSSOVER > FREQUENCY a cut-off frequency between 3000 Hz and 4000 Hz.
5. Choose under HP/SLOPE a slope value of 12dB/oct.
CONFIGURATION OF CHANNELS C/D (MIDBASS)
2. Choose the channel pair C & D under CH SETTING by clicking on the lock symbol.
3. Choose under CROSSOVER > FILTER TYPE the setting BP (bandpass filter)
4. Set under CROSSOVER > FREQUENCY a cut-off frequency between 400 Hz and 600 Hz for the HP.
Set under CROSSOVER > FREQUENCY a cut-off frequency between 3000 Hz and 6000 Hz for the LP.
5. Choose under HP/SLOPE a slope value of 12dB/oct.
6. Choose under LP/SLOPE a slope value of 12dB/oct.
CONFIGURATION OF CHANNELS E/F (KICKBASS)
2. Choose the channel pair E & F under CH SETTING by clicking on the lock symbol.
3. Choose under CROSSOVER > FILTER TYPE the setting BP (bandpass filter)
4. Set under CROSSOVER > FREQUENCY a cut-off frequency of 60 Hz for the HP.
Set under CROSSOVER > FREQUENCY a cut-off frequency of 150 Hz for the LP.
5. Choose under HP/SLOPE a slope value of 12dB/oct.
6. Choose under LP/SLOPE a slope value of 12dB/oct.
CONFIGURATION OF THE SUBWOOFER CHANNEL
2. Choose the channel pair G & H (SUB IN) under CH SETTING by clicking on the lock symbol.
3. Choose under CROSSOVER > FILTER TYPE the setting BP (bandpass filter)
4. Set under CROSSOVER > FREQUENCY a cut-off frequency for the HP between 10Hz and 30 Hz and for the LP between
50Hz and 100 Hz.
5. Choose under HP/SLOPE a slope value of 18dB/oct.
6. Choose under LP/SLOPE a slope value of 18dB/oct.
Note: The given frequency values are only guidelines and may vary depending on size and quality of the speakers and vehicle's
acoustics.
5 6
33