EMAK TN 3500 Bedienung Und Wartung Seite 108

Do not attempt to load/unload the
machine onto/from a truck while the
transport box of the machine
contains a load.
Do not allow anyone to stand
directly in front of the machine
while loading/unloading the
machine onto/from a truck.
Use the F1 gear to load and the R
gear to unload the machine. Also,
set the throttle lever to the "Low"
position, use engine braking, and
move the machine slowly.
When ascending or descending the
ramp, always center the machine on
the ramp.
When ascending or descending the
ramp, do not attempt to change the
direction in which the machine is
traveling or operate the side clutch
levers.
To ascend or descend the ramp,
establish the travel path in advance
and then move the machine at the
lowest speed.
The center of balance of the
machine will change suddenly when
the machine passes over the seam
between the ramp and the truck bed.
Be prepared for this sudden change.
When transporting the machine in
a truck or the like, secure the
machine with a sufficiently strong
rope and use blocking bars.
11