Environmentally-Friendly Disposal - Cloer 4950 Gebrauchsanweisung

contact socket at any time during the keeping
warm time, pour water and return it, which will
continue the keeping warm function.
·
You can stop the keeping warm function at
any time by pushing the keeping warm button
again.
·
Otherwise, the device will automatically switch
off after approx. 2 hours.
·
You may also switch on the keeping warm
button subsequently during a regular boiling
process.
·
For this, boil water as usual and select the
keeping warm button after pushing the ON/OFF
switch.
overheating protection device
The electric kettle is equipped with a
overheating protection. In the event that you
accidentally operate the electric kettle without
water, the device will automatically switch
off for your safety and can have no function for
a short time. Let the appliance allow to cool for
ca. 1 hour. Afterwards fill in cold water and the
device will be ready to operate again.
Cleaning
·
CAUTIoN: Do not immerse appliance or base in
water and do not clean under running water!
·
Do not clean the electric kettle with heavily
abrasive cleaners. They could scratch the
appliance.
·
Clean very dirty appliances with a damp cloth
and lukewarm water.
Removing / cleaning the lime
filter
·
The lime filter is located below the pouring
spout inside of the kettle.
·
To remove, press the upper flat edge with
your thumbs to release the two brackets. Then
remove the filter towards the top.
·
Clean the lime filter with a little bit of soapy
water and place it into the bottom hole of the
scale filter holder of the water boiler with the
bottom pin first. Then push the two upper filter
hooks back into the square holes of the holder
in the water boiler until the scale filter latches.
Decalcifying
·
If you have hard water, the electric kettle should
be decalcified regularly (depending on the
hardness of the water, about every 2 - 3 weeks).
·
Use a commercially available liquid decalcifying
product (do not use chemical decalcifiers) and
follow the manufacturer's instructions.
·
TIp: Mild calcium deposits can also be removed
with a mixture of 5 to 6 tablespoons of vinegar
in 0.5 l of water.
please observe the following when decalci-
fying the machine:
·
First, pour cold water into the electric kettle.
·
Briefly bring it to a boil.
·
Now, add the decalcifier and let the device
stand for a while.
·
CAUTIoN: Do not bring this mixture to a boil.
·
After decalcifying, rinse the pot twice with clear
water.
·
Do not clean the electric kettle with heavily
abrasive cleaners. They could scratch the
appliance.
·
NoTE: Regularly decalcifying your electric kettle
will reduce the electricity used and prolong
the life of the appliance. The calcium content
of water varies from region to region. Please
consult your local water works or utility works for
information on water hardness.
In the event of malfunctions due to calcium
deposits, the guarantee will be voided!
problem / Cause / Solution
problem possible
cause
Electric kettle Appliance
does not is not
function plugged in
Electric kettle Overheating
does not protection
function
switches off
appliance
Water bub- Too much
bles over in water has
the electric been added
kettle
Electric kettle Added to
does not little watter
switch off
Electric kettle Too much
makes loud calcification
noises during inside the
operation or electric kettle
White spots Too much
form at the calcification
bottom of inside the
the electric electric kettle
kettle
Environmentally friendly disposal
We use only environmentally friendly packaging
for the transport of our appliances. Please
recycle cardboard/paper and plastic packaging
appropriately.
CAUTIoN!
Electrical appliances should
not be disposed of with
the household trash.
Electrical appliances contain valuable raw
materials. When an appliance is worn-out, please
take it to a recognised recycling facility. Please
consult the local authorities for information on
recycling appliances.
Customer service
In the event that your Cloer appliance becomes
defective, please contact your Cloer dealer
or Cloer customer service department. Cloer
electrical appliances comply with current EC
guidelines and safety regulations.
Conditions of warranty
Cloer grants you, the private end user, a
EN
Solution
Plug the
power plug
into the
wall socket
Please see
page 9 under
"Overheating
protection
device"
Add less
water, do not
exceed the
MAX marking
Add more
water / do
not come
below the
MIN marking
(= 0.8 l)
Decalcify
the electric
kettle
Decalcify
the electric
kettle
9