Automatic On / Off Function (Aut) - Canton Digital Movie 5 Bedienungsanleitung

English
Setup functions

Automatic ON / OFF function (AUT)

When this function is activated (ON) the device identifies a signal through the optical or coaxial input. When a signal is detected (e.g. by
switching on the source device) the DM system turns itself on. If no such signal is detected on the selected input (e.g. when the source device
has been switched off) the DM system will automatically enter AUT standby mode after 30 seconds. When the function is deactivated
(OFF) the DM system needs to be switched on and off manually.
The device is supplied with the function deactivated (OFF).
To activate / deactivate this function proceed with the following steps:
With the device switched on, press and hold the "Play Mode" key for more
1
than 3 seconds, until
Press the "Volume +" key to activate the function (ON).
2
Press the "Volume –" key to deactivate the function (OFF).
3
Exit the menu by again pressing and holding the "Play Mode" key for more
4
than 3 seconds. If no input has appeared within 10 seconds the device will
automatically exit the configuration menu.
Comment: The automatic switching on / off function only works for optical and coaxial digital input. If the device is set to standby mode
using the "ON / Standby" key on the remote control it is not possible for the device to switch on automatically.
The device only identifies a signal at the selected digital input. A signal that appears at the other than the selected digital input cannot be
detected.
48
appears on the display.
AUT
ON MUTE
STANDBY
STEREO BASS
SURROUND TREBLE
TV remote control