Herunterladen Inhalt Inhalt Diese Seite drucken

Decals - Jacobsen HR-5111 Wartung Und Service

Rotary mower with rops
Vorschau ausblenden Andere Handbücher für HR-5111:
Inhaltsverzeichnis

Werbung

HR-5111

1.1 Decals

!
WARNING
Fit roll over protective
structure before using
this machine on slopes
greater than 14 .
Do not use on slopes
greater than 21 .
Keep bystanders away
14
22
J-T 3002556 CA
16
17
13
15
!
CAUTION
1. Do not operate tractor with horn sounding. Horn will sound to warn of overheated engine or hydraulic system.
See instructions in operators manual to properly clean the radiator or oil cooler and check fluid levels.
2. When implement becomes clogged, disengage power and stop engine before cleaning.
3. Keep hands, feet and clothing away from power driven moving parts.
4. Do not ride on machine or allow passengers unless seat is provided.
5. Keep all shields in place.
6. Stop engine for all servicing, adjustments, or fluid level changes.
7. Read manual thoroughly before operating machine.
8. Do not shift between 2WD / 4WD while tractor is moving
21
Tow valve to be used in case of
emergency only. Excess towing
may damage hydraulic system.
Before towing vehicle, turn
valve 90 to de-clutch. Do not turn
valve while machine is in motion.
1
2
OPERATING INSTRUCTIONS
READ MANUAL THOROUGHLY FOR OPERATING AND SAFETY INSTRUCTIONS.
REPLACEMENT MANUAL AVAILABLE FROM: JACOBSEN/TEXTRON, 1721 PACKARD AVENUE, RACINE WI, 53403.
TO START
TO TRANSPORT
TO MOW
1. Set Parking Brake.
1. Place implement switch
1. Lower cutting units
2. Set Speed Control
in off position.
to ground.
treadle in neutral.
2. Raise cutting units
2. Set rocker switch
3. Place implement switch
and engage transport
in cut position for
in off position.
latches.
mowing (and reverse
4. Set throttle at half
3. Release parking brake
position for
position.
4. Set throttle to
clearing
5. For cold starting,
fast position.
obstructions from
hold glow switch
5. Depress treadle
reels, ST-5111 only).
for seven seconds,
pedal for desired
3. Place implement switch
release switch.
ground speed.
in on position.
6. Turn ignition switch
4. Release parking
to start position.
brake.
5. Set throttle to fast
position.
6. Depress treadle
pedal for desired
ground speed
Vehicle Weight Wet:
4340 lb
1970 kg
ST 5111
Vehicle Horsepower:
49 HP
36.5 kW
Vehicle Weight Wet:
3301 lb
1534 kg
HR 5111
Vehicle Horsepower:
50 HP
37.2 kW
32
!
WARNING
To prevent serious injury
never disconnect or tamper
with the seat switch.
Read the manual for more information.
32
DAILY SERVICE INSTRUCTIONS
Read Manual thoroughly before operating for maintenance instructions.
Maintain fluid level in radiator recovery tank between
"Full" and "Low" mark when engine is cold.
Clear the radiator core & radiator screen of any dirt
or grass clippings.
Check the engine oil each time you stop for fuel.
IMPORTANT
Empty air cleaner dust cap daily.
19
Read operators manual for more detailed service
instructions.
3
J-T 364907 CA
!
To avoid injury when working with battery
TO STOP
TO BACKLAP (ST-5111 ONLY)
PARKING BRAKE
1. Always connect the black ground (–)
1. Set treadle pedal
1. Engage parking
cable last and remove it first.
in neutral position.
brake.
2. Keep sparks and flames away, and
2. Place implement switch
2. Start engine and
in off position.
set throttle to
avoid contatc with acid.
3. Set parking brake.
minimum idle speed.
4. Set throttle to
3. Engage implement
To avoid injury when jumping battery
slow position.
switch for
1. Connect positive (+) terminal to
5. Turn ignition to
backlapping.
ON
off position and
4. Set desired rocker
positive (+) terminal.
remove key.
switch to reverse,
2. Connect negative (–) terminal on good
set other switch
battery to frame of vehicle that
in center (OFF)
has dead battery.
position.
OFF
5. With extreme caution,
apply lapping
compound with long
handled brush.
To Engage: Pull Up
To Release: Push Down
At 2500 RPM
At 2800 RPM
J-T 3002541
10
10
30
10
30
18
!
Filter is under pressure. Remove
filter slowly to avoid bodily injury
PUSH TO LATCH
WING ARMS.
PULL TO RELEASE
6
Fill oil tank to 2 inches below filler neck
USE JACOBSEN
HYDRAULIC FLUID
SEE MANUAL FOR
SPECIFCATIONS
30
7
20
HR-5111
DANGER
ADVERTENCIA
!
1. Leer el manual del operador. No permitir que
personas no capacitadas para ello usen la maquina
2. Mantenae los escudos en su lugar y la tornilleria
debidamente fijada.
3. Antes de limpiar, ajustar o reparar este equipo,
desengranar todas los mandos, aplicar el freno de
estacionamiento y apagar el motor.
4. Mantener las manos, los pies y la ropa alejados de
las piezas en movimiento.
5. No viajar como pasajeros ni llevar pasajeros en
maquinas sin asiento para ellos.
6. Mantener a las demas personas alejadas
7. Si no sabe leer ingles, solicitarle a otra persona que
le lea y explique el contenido de las etiquetas y del
manual de la maquina.
5
Radiator is under pressure. Remove
cap slowly to avoid personal injury
WARNING
24
IMPORTANT
DO NOT USE STARTING
31
ASSIST FLUIDS
USE OF STARTING ASSIST FLUIDS IN THE
AIR INTAKE SYSTEM MAY BE POTENTIALLY
EXPLOSIVE OR CAUSE A "RUNAWAY"
ENGINE CONDITION. THIS COULD RESULT
IN SERIOUS ENGINE DAMAGE.
28
!
CAUTION
DANGER
KEEP HANDS AND FEET AWAY
DO NOT OVERFILL
29
23
THIS RADIATOR CONTAINS
ANTI-FREEZE
PROTECTED TO -26 F (-32 C)
Mix equal parts of clean water and a premium
quality ethylene glycol based anti-freeze to
maintain the boil over, rust and corrosion
protection.
Drain and discard coolant yearly. Read manual
for additional instructions.
12
11
8
4
Serial No. 69158 All
!
WARNING
!
WARNING
To prevent burns, do not touch
muffler or muffler shield.
Temperatures may exceed 150¡F (66¡C)
27
WARNING
!
DO NOT USE FOR TOWING
26
25
4WD
10
9

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis